Roasted self drying hardware ink
1. The roasted self drying hardware ink is two liquid reactive ink, but its drying speed is faster than the same type ink. It has higher production efficiency. It has high adhesion and high moisture resistance and solvent resistance to various materials. It is especially suitable for metal metal blackening material, galvanizing, 304 stainless steel metal material; titanium alloy. Gold and processed polyethylene, polypropylene and other materials. The product is resistant to alcohol, friction and bending.
2, ink mixing method: ink plus curing agent 15% and diluent 3-10% diluted to print suitable for the printing viscosity full mixing, according to the actual conditions of printing to select diluents: fast dry, dry, slow dry diluent, the general situation for cold days (less than 15 degrees) selected fast drying agent, hot weather (> 30 degrees C) selection Use slow drying agent.
3、干燥时间： 常温26度10分钟指触抹不沾手，完全干透可测试时间时间24小时，低于常温干燥时间会延长，应急强制干燥：高温 130度恒温烘烤20分钟，等产品冷却后可以做物理破坏检测
3, drying time: 26 degrees 10 minutes at normal temperature refers to the touch of non touch hand, completely dry test time and time 24 hours, lower than normal temperature drying time will extend, emergency forced drying: high temperature 130 degrees of constant temperature baking for 20 minutes, and other products can do physical damage detection after cooling test.
4, color: 26 color common color, other special colors can be adjusted; the room temperature mixed curing agent time is 8 hours; expired please prudently, plus other additives remaining ink can not be recycled raw ink.
5. No combination of other types of ink can be used without trial. Otherwise, other adhesion, chemical reactions and other bad phenomena are likely to occur.
1. the appearance of all kinds of printing materials is similar. It is necessary to confirm whether the materials of the substrate are in conformity with each other, and that the customers need to try them out first.
2. before printing, remove the dust and oil stains on the surface of the printing parts. It can be removed by alcohol or water to promote the effect of attachment. In the process of printing, some slow dry ointments can be properly added, such as drawing or dispersing.
3. the adhesion will be unstable if the temperature is below 20 degrees. If the temperature is too low, the adhesion of the ink will be lower than 10 degrees.
4. pay attention to the humidity and humidity of the workshop, which will affect adhesion.
5. Attention should be paid to ventilation in the construction site when using. Try to avoid direct skin contact
6, this product splashes into the mouth, nose, eyes and ears, and applies a lot of water to clean or seek help from the doctor directly.
7. Allergic to this product should be coated with a skin cream or an impermeable glove before use.
8, according to climate change, please keep away from fire sources, and store in sealed environment at 10 degrees -25 in the shade. Ink and thinner are strictly forbidden to touch fireworks.
淘宝店 搜 欧帝斯油墨
Taobao store inks
The above color pulp is measured by the non medical standard of ROSH standard by SGS. The above information is recorded as the company's laboratory data, only for reference, no guarantee and commitment basis. Before large batch production, it is necessary to test the batch production according to the customer's requirements and do not comply with all the losses caused by the above operation methods. No responsibility!